Material

Stainless steel management theory weight calculation formula: (outer diameter - wall thickness) × wall thickness × density = kg...

This calculator is calculated based on the resistivity of the ambient temperature of the wire around 20 °. The power factor was...

App Description Volume of liquid in storage: \[ V=V1+V2= \frac {πd}{4} LK+0.2155h^2(1.5d-h) \] In the formula: V1-volume part v...

App Description Permeability coefficient calculation formula: \(K=QA \times LH\) In the formula: QA - the amount of water per u...

Dynamic viscosity unit conversion 1 Pa. Second = 10 Poise = 1000 cps = 3600 kg / m. Hour 1 pound thrust. Seconds per square inc...

App description Estimate the temperature rise coefficient (Celsius/Watt) based on the effective area of the heat sink (cm 2 ) f...

The theoretical weight calculation formula of stainless steel plate: Densitylengthwidth*thickness=kg/block 201, 202, 206, 301,...

Stainless steel round steel theoretical weight calculation formula: 0.7854outer diameterouter diameterlengthdensity/1000=kg/root

App Description Gt = Actual proportion W1 = S.G bottle weight W2 = S.G bottle weight + powder sample weight W3 = S.G bottle we...

This simple calculator is a quick estimate of general liquid flow parameters. It can estimate fluid flow, velocity, time calibe...

App Description Calculation formula \(absorbency = \frac {S-W}{W} \times 100%\) S = weight of the workpiece after soaking W = d...

App Description Input data: high pass impedance: ohm; low pass impedance: ohm; frequency Hz Output data: C1 = μf; L1 = mH; C2 =...

App Description Because of its simple production and easy material selection, J-type antenna has been favored by FM transmitte...

Porosity =\( ( 1 - ( Ga / Gt ) ) ×100 )\) In the formula: Ga - bulk density of bulk material; Gt - apparent density of bulk mat...

App Description Air flow rate unit conversion The speed of the air is measured at a specific location, with respect to the meas...

App Description Usage example Hole diameter (D): Center spacing (C): Click Calculate to output the data: Opening ratio (OA): %...